Instructions for installing the deskside and rack-mounted 7036-P16
device.
Purpose
The following information describes the materials
and procedures for installing this device. A Phillips screwdriver is required
to complete the installation of this unit.
7036-P16 hardware package contents
Before you install
the 7036-P16 unit, verify that the hardware package contains the following
items:
- 7036-P16 unit
- 7036-P16 software and documentation CD
- 7036-P16 Quick Setup Guide
- Brackets to mount 7036-P16 on rack
- Rubber feet for table top usage
- Power cord (North American 120 VAC use only)
- RJ-45 to DB25 serial cable DB25 wired per EIA-232 specification
- RJ-45 to DB09 serial cable DB09 matches pin configuration on existing
DB09 system ports on IBM System p5™ or eServer™ p5 systems
- RJ-45 wrap plug for diagnostics.
Deskside 7036-P16 unit installation procedure
To install
the deskside 7036-P16 unit, do the following:
- Unpack the hardware.
- Remove the rubber feet from the plastic bag.
- Attach the rubber feet to the bottom of the 7036-P16 in the locations
indicated.
- Attach the power cord. A power cord for use in North America is provided.
- Use an Ethernet cable to connect the 7036-P16 to the network.
- Connect serial devices as needed.
Rack-mount unit installation procedure
To install the
rack-mount 7036-P16 unit, do the following:
- Unpack the hardware.
- Remove the right-angle brackets and screws from the plastic bag.
- Use a Phillips screw to attach the brackets in the pre-drilled holes on
the sides of the 7036-P16.
- Mount the 7036-P16 in the same location from which the 7036-P16 was removed.
- Attach the power cord. A power cord for use with 120 VAC is provided.
Optional
rack power cord feature codes (FC) are available to connect the 7036-P16 to
the rack Power Distribution Unit (PDU). These cords come in various lengths.
They are identified by the following feature codes:
- FC 6458: Power Cord (14-foot), Drawer to IBM® PDU, 250V/10A
- FC 6672: Power Cord (9-foot), Drawer to IBM PDU, 250V/10A
- FC 6671: Power Cord (5-foot), Drawer to IBM PDU, 250V/10A
The previous features are only available for use
in racks less than 25U in size.
- Use an Ethernet cable to connect the 7036-P16 to the network.
- Connect serial devices as needed.