Disk Unit

Use this procedure to service the disk unit.

  1. The disk unit will be serviced non-concurrently.

    Remove power from the enclosure containing the FRU. Powering off the enclosure is accomplished through the enclosure's host server. For additional information, refer to the "Powering on and powering off" topic located in the host server's service guide.

  2. Attention:

    Failure to follow the step-by-step sequence for this FRU removal and/or installation may result in FRU or system damage.

    Use the following precautions whenever you handle electronic components or cables.

    • Attach a wrist strap to an unpainted metal surface of your hardware to prevent electrostatic discharge from damaging your hardware.
    • If you do not have a wrist strap, just prior to removing the product from ESD packaging and installing or replacing hardware, touch an unpainted metal surface of the system for a minimum of 5 seconds.
    • Keep all electronic components in the shipping container or envelope until you are ready to install them.
    • If you remove, then re-install an electronic component, temporarily place the component on an ESD pad or blanket, if available.
  3. Remove the disk unit.

    1. Press the latch on the right end of the disk unit handle to release the disk unit from its slot.
    2. Pull out the handle (A) to the open position.
    3. This action releases the disk unit from its slot.
    4. Grasp the front of the disk unit and pull it out of the bay, supporting the bottom of the drive while you do this.
  4. Install the disk unit.

    1. With the handle (A) in the unlocked position, support the bottom of the disk unit as you align it with the guide rails in the expansion unit.
    2. Slide the disk unit into the expansion unit.
    3. Push the handle towards the disk unit to lock it into place.

  5. Power on the enclosure.

    Power on the enclosure containing the FRU. Powering on the enclosure is accomplished through the enclosure's host server. For additional information, refer to the "Powering on and powering off" topic located in the host server's service guide.