FSPSP30

This error occurred before VPD collection was completed. No location codes have been created.

Refer to Locating FRUs for instructions for removing and replacing any FRUs called out by the following procedure.

1. Power off the system (see Powering on and powering off) and remove ac power.
2. Clear any deconfiguration errors for the VPD card.
3. Replace the VPD card (Un-P1-C9).
4. Perform a slow boot. Refer to Performing a slow boot).

   Does the problem persist?

   • Yes: Continue with the next step.
   • No: Go to Verifying a repair. This ends the procedure.
5. Power off the system (see Powering on and powering off).
6. Replace the system backplane (Un-P1).
7. Perform a slow boot. Refer to Performing a slow boot.

   Does the problem persist?

   • Yes: Contact your next level of support. This ends the procedure.
   • No: Go to Verifying a repair. This ends the procedure.