FSPSP32

A problem with the enclosure has been found.

The problem is resulting from one of the following:

Refer to Locating FRUs for instructions for removing and replacing any FRUs called out by the following procedure.

Perform the following:

  1. Record the reason code (the last 4 characters of word 11) from the SRC by looking at the operator panel or accessing the error log with the ASMI.
  2. Is the reason code A46F?
  3. Check for and apply any server firmware updates. Does the problem persist?
  4. Power off the system (see Powering on and powering off).
  5. Perform the following:
    1. Replace the system backplane (Un-P1).
    2. Perform a slow boot (see Performing a slow boot).

    Does the problem persist?

  6. Is the reason code A460?
  7. Perform the following:
    1. Set the enclosure serial number using the ASMI (see Setting the system identifiers).
    2. The service processor will automatically reset when leaving the ASMI after updating the serial number.
    3. Perform a slow boot (see Performing a slow boot).

    Does the problem persist?

  8. Is the reason code A45F?
  9. Perform the following:
    1. Set the enclosure feature code using the ASMI (see Setting the system enclosure type).
    2. The service processor will automatically reset when leaving the ASMI after updating the serial number.
    3. Perform a slow boot (see Performing a slow boot).).

    Does the problem persist?