Verify that the fix installed correctly

Choose from the following options:
- To use the AIX^(R) or Linux^(R) command prompt (the operating system must be running and the diagnostics must be available), continue with the next step.
- To use the ASMI, view the level of server firmware displayed in the upper-right corner below the copyright statement on the ASMI Welcome pane; for example, SF220_006. If the level of server firmware displayed is not the level that you installed, see Failed verification that the fix installed successfully.
Enter the following at a command prompt:
```
lsmcode
```
The existing levels of server firmware are displayed. For example, you might see output similar to the following:
```
The current permanent system firmware image is SF220_005.
The current temporary system firmware image is SF220_006.
The system is currently booted from the temporary image.
```
Note:
1. The permanent level is also known as the backup level.
2. The temporary level is also known as the installed level.
3. The system was booted from the temporary side, so at this time the temporary level is also the activated level.
Verify that the level of server firmware displayed is the level that you installed.
If the level of server firmware displayed is not the level that you installed, perform the following steps:
1. Retry the update. If you created a CD or DVD for this procedure, use a new media.
2. If the problem persists, contact your next level of support.