Apply the server firmware update through the USB port on the service processor assembly

1. Ensure the server is in the Standby state.
2. Insert the USB flash drive into the USB port on the service processor assembly. The firmware level will load automatically. The level of firmware on the USB flash drive will be installed onto both the P and T sides of the service processor assembly.

   Several checkpoints will be posted on the control (operator) panel during the installation of the firmware:

   • C100B101: The firmware image is being installed on a side of the flash.
   • C100B102: The firmware image is being installed on the other side of the flash.
   • C100B103: The firmware installation has been completed successfully.
     Note:
     If a C100B104 code appears, it means that the firmware installation has failed. Perform the following steps:

     1. Ensure that the USB flash drive contains the firmware update. If necessary, copy the firmware to the USB flash drive again.
     2. Retry the task with a different USB flash drive.
     3. If necessary, replace the service processor assembly.
3. Continue with Verify that the fix installed correctly.