FSPSP19

This procedure is usually called out due to a maintenance action dealing with an MCM and indicates that the plug count has been exceeded or is incorrect.

1. Log on to the ASMI (see Accessing the Advanced System Management Interface).
2. Select System Configuration -> Interposer Plug Count.
3. Find the target location code for the corresponding interposer.
4. Increment the interposer count by one.
5. Does the plug count exceed 10?
   • Yes: Perform the following:
     1. Power off the system (see Powering on and powering off).
     2. Replace the processor card for the interposer card that has exceeded 10.
     3. Reset the plug count to one (1) with the ASMI.
     4. Perform a slow boot, refer to Performing a slow boot, and handle any new serviceable events as new problems. This ends the procedure.
   • No: Perform a slow boot, refer to Performing a slow boot, and handle any new serviceable events as new problems. This ends the procedure.