FSPSP43

Use this procedure when you are performing a cold service processor replacement and the system uses static IP addressing for Advanced System Management Interface (ASMI) and Hardware Management Console (HMC) network connections.

  1. Does the system use static IP addressing?
  2. Configure the network interfaces by using static IP addresses. (See Configuring network interfaces.)
  3. Remove AC line power from both drawers that contain the service processors.
  4. Plug in the AC line power for the drawer that contains the original service processor (the one you are not replacing).
  5. Wait for the original service processor to come to Power On Standby.
  6. Plug in the AC line power for the drawer that contains the new service processor.
  7. Return to the HMC Repair and Verify flows to indicate that power has been applied to the new service processor. (For more information, see from the HMC)This ends the procedure.