SIP3148

Use this procedure to resolve the following problem: Attached enclosure does not support required multipath function (SRC xxxx4050).

The possible cause is the use of an unsupported device enclosure.

Considerations:

Power off the system, partition, or card slot before connecting and disconnecting cables or devices, as appropriate, to prevent hardware damage.

Identify the adapter and adapter port associated with the problem by examining the product activity log. Perform the following steps:
1. Access SST or DST.
  - If you can enter a command at the console, access system service tools (SST). See System service tools .
  - If you cannot enter a command at the console, perform an IPL to DST. See Performing an IPL to dedicated service tools .
  - If you cannot perform a type A or B IPL, perform a type D IPL from removable media.
2. Access the product activity log and record address information.
  If a type D IPL was not performed to get to SST or DST:
  
  The log information is formatted. Access the product activity log and display the SRC that sent you here. Press the F9 key for address information. This is the adapter address. Then, press F12 to cancel and return to the previous screen. Then press the F4 key to view the additional information to record the formatted log information. The Adapter Port field indicates the port on the adapter reporting the problem. There may be more than one port listed because multiple ports map to the same physical connector. For example, ports 0 through 3 map to the first physical connector, 4 through 7 map to the second physical connector, and so on. The port numbers are labeled on the adapter tailstock.
  
  If a type D IPL was performed to get to DST:
  
  The log information is not formatted. Access the product activity log and display the SRC that sent you here. The direct select address (DSA) of the adapter is in the format BBBB-Cc-bb:
  BBBB
  
  Hexadecimal offsets 4C and 4D
  
  Cc
  
  Hexadecimal offset 51
  
  bb
  
  Hexadecimal offset 4F
  
  In order to interpret the hexadecimal information to get device addresses, see More information from hexadecimal reports . The Adapter Port field indicates the port on the adapter reporting the problem. There may be more than one port listed because multiple ports map to the same physical connector. For example, ports 0 through 3 map to the first physical connector, 4 through 7 map to the second physical connector, and so on. The port numbers are labeled on the adapter tailstock.
3. Determine the location of the adapter that reported the problem. See System FRU locations and find the diagram of the system unit or the expansion unit. Then find the following items:
  - The card slot that is identified by the direct select address (DSA)
  - The physical connector identified by the port number found on the adapter tailstock
  Have you determined the location of the adapter and its port?
  No:
  
  Ask your next level of support for assistance. This ends the procedure.
  
  Yes:
  
  Continue with the next step.
If unsupported device enclosures are attached to the identified adapter port, then either remove or replace them with supported device enclosures.
Perform the following steps to cause the adapter to rediscover the devices and connections:
1. Use Hardware Service Manager to perform another IPL of the virtual I/O processor that is associated with this adapter.
2. Vary on any other resources attached to the virtual I/O processor.
Did the error recurr?
No:

This ends the procedure.

Yes:

Contact your hardware service provider. This ends the procedure.