FSPSP01

A part vital to system function has been deconfigured. Review the system error logs for errors that callout parts relevant to each reason code. If replacing those parts does not resolve the error, follow the procedure below.

Refer to Locating FRUs for instructions for removing and replacing any FRUs called out by the following procedure.

Perform the following steps:

Is SRC B1xxB10C or B1xxB10D (xx indicates that the Subsystem ID is irrelevant)?
- No: Go to step 5.
- Yes: The system has detected a deconfigured memory controller that is required for the system to function, or it has detected that there is not enough memory or that the memory DIMM is plugged incorrectly. Continue with the next step.
Perform the following steps:
1. Reseat all of the memory DIMMs on the system backplane but do not replace any memory DIMM at this time.
2. Perform a slow boot, refer to Performing a slow boot.
Does the problem persist?
- Yes: Continue with the next step.
- No: Go to Verifying a repair. This ends the procedure.
Use the following procedure to replace memory DIMMs, and perform a slow boot after each replacement until the problem is resolved. Memory DIMMs must be installed in quads and in the correct connectors. Refer to Physical Locations for information on memory DIMMs.
1. Replace the first memory DIMM quad.
2. Perform a slow boot, refer to Performing a slow boot .
Does the problem persist?
- Yes: Repeat this step and replace the second memory DIMM quad. If you have replaced both of the memory DIMM quads, then continue with the next step.
- No: Go to Verifying a repair. This ends the procedure.
Use the following procedure to replace the system backplane.
1. Replace the system backplane (Un-P1).
2. Perform a slow boot, refer to Performing a slow boot .
Does the problem persist?
- Yes: Contact your next level of support. This ends the procedure.
- No: Go to Verifying a repair. This ends the procedure.
Is SRC B1xxB107 or B1xxB108?
- No: Continue with the next step.
- Yes: The system has detected a problem with the clock module. Replace the system backplane (Un-P1). This ends the procedure.
Is SCR B1xxB106?
- No: Continue with the next step.
- Yes: The system has detected that the system backplane is deconfigured. Perform the following:
  1. Replace the system backplane (Un-P1).
  2. Perform a slow boot, refer to Performing a slow boot .
  3. Go to Verifying a repair. This ends the procedure.
Is SRC B1xxB110 or B1xxB111?
- No: Contact your next level of support. This ends the procedure.
- Yes: The system has detected that the I/O bridge is deconfigured. Perform the following:
  1. Replace the system backplane (Un-P1).
  2. Perform a slow boot, refer to Performing a slow boot .
  3. Go to Verifying a repair. This ends the procedure.