Replace the disk drive nonconcurrently

Use this procedure to remove and replace a disk drive nonconcurrently.
  1. Power off the system

    The component will not be serviced concurrently.

    If this system is powered on, power it off before continuing.

    If possible, shut down any running applications and the operating system before powering off the system.

  2. Remove the disk drive

    1. Pinch the two surfaces of the latching mechanism together and pull the handle (A) towards you to release the DASD from the slot.
    2. Label and remove the DASD from the system by sliding it straight out of the I/O unit.

  3. Install the disk drive

    Install the DASD into the proper location in the IO unit by sliding it in with the handle (A) out, then pushing the handle towards the unit to lock it into place.
  4. Verify the repair
    Go to Verifying a repair. This completes this procedure.