Configuring Fujitsu ETERNUS systems

This section provides information about configuring the Fujitsu ETERNUS systems for attachment to a SAN Volume Controller.

Supported models of the Fujitsu ETERNUS
The SAN Volume Controller supports models of the Fujitsu ETERNUS series of systems.
Supported firmware levels for the Fujitsu ETERNUS
The Fujitsu ETERNUS must use a firmware level that is supported by the SAN Volume Controller.
User interfaces on the Fujitsu ETERNUS
Ensure that you are familiar with the user interface application that is used by the Fujitsu ETERNUS.
Configuring the Fujitsu ETERNUS to use with the SAN Volume Controller
Ensure that you use the settings that are required to use the Fujitsu ETERNUS with the SAN Volume Controller. It is important that you use the correct settings to avoid data access problems.
Zoning configuration for the Fujitsu ETERNUS
If LUN mapping mode is used for a Fujitsu ETERNUS port, you must exclusively zone the SAN Volume Controller with this target port.
Migrating logical units from the Fujitsu ETERNUS to the SAN Volume Controller
You can use the standard migration procedure with the following restrictions:
Concurrent maintenance on the Fujitsu ETERNUS
Concurrent maintenance is the capability to perform I/O operations to a Fujitsu ETERNUS while simultaneously performing maintenance operations on it.
Advanced functions for the Fujitsu ETERNUS
The Fujitsu ETERNUS system provides several Advanced Copy functions. Do not use these Advanced Copy functions for storage that is managed by the SAN Volume Controller, even if the VDisk cache is disabled.

Parent topic: Configuring and servicing storage systems