Removing the SAN Volume Controller 2145-8A4 cable retention bracket

The cable-retention bracket attaches to the back of the SAN Volume Controller 2145-8A4 node. It is connected with one screw that already holds the rear plate of the power supply in place.

1. With the node turned off, unscrew the retaining screw , shown in Figure 1, half a turn, but do not fully loosen or remove it.
   Figure 1. SAN Volume Controller 2145-8A4 with the cable-retention bracket installed
2. Slide the bracket to the right just enough to disengage the screw.
3. Squeeze the top and bottom of the bracket together slightly and turn the bracket at a slight angle to remove both lips of the bracket from the node frame.
4. Slide the bracket back onto the power cable and then slide it off the cable.
5. Remove the power cable.