Removing the SAN Volume Controller 2145-CF8 operator-information panel cable

Use these instructions when you are prompted to remove the operator-information panel cable from the SAN Volume Controller 2145-CF8.

DANGER
Multiple power cords. The product might be equipped with multiple power cords. To remove all hazardous voltages, disconnect all power cords.
This service action assumes that:
  • The node is turned off. If you must turn off the node, ensure that its data is mirrored and synchronized, and that there are no dependent virtual disks (VDisks), as described in MAP 5350: Powering off a SAN Volume Controller node.
  • The power cables are disconnected.
  • The top cover is removed.
Perform the following steps to remove the operator-information panel cable:
  1. Read the safety information to which Preparing to remove and replace parts refers.
  2. Disconnect the cable from the rear of the operator-information panel.
  3. Disconnect the cable from the connector above the Video/USB cable connector on the right side of the node, as shown in Figure 1.

    The following illustration shows the cable routing for the operator-information panel cable.

    Figure 1. Disconnecting the SAN Volume Controller 2145-CF8 operator-information panel cable
    Disconnecting the SAN Volume Controller 2145-CF8 operator-information panel cable
    •  1  Operator-information panel connector
    •  2  Operator-information panel cable
  4. Lift the cable from the node.
  5. Replace the cable before proceeding.
Parent topic: Removing the operator-information panel cable
Library | Support | Terms of use | Feedback
© Copyright IBM Corporation 2003, 2009. All Rights Reserved.