Removing a SAN Volume Controller 2145-8G4 power supply

This topic describes how to remove a SAN Volume Controller 2145-8G4 power supply.

Ensure that you are aware of the procedures for handling static-sensitive devices before you remove the SAN Volume Controller 2145-8G4 power supply.
Perform the following steps to remove the power supply:
  1. Turn off the node while ensuring that its data is mirrored and synchronized. See MAP 5350: Powering off a SAN Volume Controller node for more information.
  2. At the back of the node, remove the cable restraint bracket to gain access to the rear of the node and the power supply reference key one.
  3. Press and hold down the orange release tab reference key two, which is shown in Figure 1, and pull the power supply out of the node.
    Figure 1. SAN Volume Controller 2145-8G4 power supplySAN Volume Controller 2145-8G4 power supply
    • reference key one Power supply
    • reference key two Power supply release tab
    • reference key three Power supply handle
Parent topic: Removing the power supply
Library | Support | Terms of use | Feedback
© Copyright IBM Corporation 2003, 2009. All Rights Reserved.