Removing the SAN Volume Controller 2145-8A4 top cover

This topic describes how to remove the top cover of the SAN Volume Controller 2145-8A4 node.

Attention: Never remove the top cover with power applied. To remove all power from the node, see MAP 5350: Powering off a SAN Volume Controller node.

To remove the SAN Volume Controller 2145-8A4 cover, complete the following steps.

  1. Read the safety information that is referenced in Preparing to remove and replace parts.
  2. Remove the node from the rack and place it on a flat, static-protective surface. See Removing the SAN Volume Controller from a rack.
  3. Press the cover-release button Reference key one, which is shown in Figure 1.
    Figure 1. Removing the SAN Volume Controller 2145-8A4 coverThis figure illustrates the cover-release button on the SAN Volume Controller 2145-8A4
  4. Slide the cover back approximately 1.3 cm (0.5 in); then, lift it off the node.
Parent topic: Removing the top cover
Library | Support | Terms of use | Feedback
© Copyright IBM Corporation 2003, 2009. All Rights Reserved.