MAP 5700: Repair verification

MAP 5700: Repair verification helps you to verify that field-replaceable units (FRUs) that you have exchanged for new FRUs, or repair actions that have been done have solved all the problems on the SAN Volume Controller.

1. Are the Power LEDs on all the SAN Volume Controller nodes on?
   For more information about this LED, see Power LED.

   NO

   Go to MAP 5000: Start.

   YES

   Go to step 3.

2. Are the Power LEDs on all the SAN Volume Controller nodes on?
   For more information about this LED, see Power LED.

   NO

   Go to MAP 5000: Start.

   YES

   Go to step 4.

3. (from step 1)

   Are the Check LEDs on all SAN Volume Controller nodes off? For more information about this LED, see Check LED.

   NO

   Go to MAP 5000: Start.

   YES

   Go to step 4.

4. (from step 32)

   Are all the SAN Volume Controller nodes displaying Cluster: on the top line of the front panel display with the second line blank or displaying a cluster name?

   NO

   Go to MAP 5000: Start.

   YES

   Go to step 5.

5. (from step 4)

   Using the SAN Volume Controller application for the cluster you have just repaired, check the status of all configured managed disks (MDisks).

   Do all MDisks have a status of online?

   NO

   If any MDisks have a status of offline, repair the MDisks. See Determining the failing enclosure or disk controller using the CLI to locate the disk controller with the offline MDisk. Use the problem determination procedure for the disk controller to repair the MDisk faults before returning to this MAP.

   If any MDisks have a status of degraded paths or degraded ports, repair any storage area network (SAN) and MDisk faults before returning to this MAP.

   If any MDisks show a status of excluded, include MDisks before returning to this MAP.

   Go to MAP 5000: Start.

   YES

   Go to step 6.

6. (from step 5)

   Using the SAN Volume Controller application for the cluster you have just repaired, check the status of all configured virtual disks (VDisks).

   Do all VDisks have a status of online?

   NO

   Go to step 7.

   YES

   Go to step 8.

7. (from step 6)

   Following a repair of the SAN Volume Controller, a number of VDisks are showing a status of offline. VDisks will be held offline if SAN Volume Controller cannot confirm the integrity of the data. The VDisk might be the target of a copy that did not complete, or cache write data that was not written back to disk might have been lost. Determine why the VDisk is offline. If the VDisk was the target of a copy that did not complete, you can start the copy again. Otherwise, write data might not have been written to the disk, so its state cannot be verified. Your site procedures will determine how data is restored to a known state.

   To bring the VDisks online, you must move all the offline disks to the recovery I/O group and then move them back to an active I/O group. See Recovering from offline VDisks for details on how to resolve this problem.

   Go to MAP 5000: Start.

8. (from step 6)

   You have successfully repaired the SAN Volume Controller.