Replacing the SAN Volume Controller 2145-4F2 top cover

Before moving the top cover into place, position the internal cables so that they do not interfere with the cover.
Important: Before you slide the cover forward, make sure that all the tabs on both the front, rear, and side of the cover engage the chassis correctly. If all the tabs do not engage the chassis correctly, it will be very difficult to remove the cover later.

Perform the following steps to replace the top cover on the SAN Volume Controller 2145-4F2:

  1. Ensure that the lever number one is fully up as shown in Figure 1.
    Figure 1. SAN Volume Controller 2145-4F2 with the fan door open
    SAN Volume Controller 2145-4F2 with the fan door open
  2. Place the cover onto the node so that about 13 mm (0.5 in.) of the cover protrudes over the back edge of the SAN Volume Controller 2145-4F2 frame.
  3. Press the lever downward. The top cover moves toward the front of the node.
  4. Ensure that top fingers and back lugs of the cover correctly engage the frame of the node.
  5. Press the lever until it fully engages.
Parent topic: Replacing the top cover
Library | Support | Terms of use | Feedback
© Copyright IBM Corporation 2003, 2009. All Rights Reserved.