Replacing the SAN Volume Controller 2145-8G4 top cover

This topic describes how to replace the SAN Volume Controller 2145-8G4 top cover.

Important: Before you slide the cover forward, make sure that all the tabs on both the front, rear, and side of the cover engage the chassis correctly. If all the tabs do not engage the chassis correctly, it will be very difficult to remove the cover later.

To replace the top cover on the SAN Volume Controller 2145-8G4, complete the following steps:

  1. Position the internal cables so that they do not interfere with the cover installation.
  2. Position the cover on top of the SAN Volume Controller 2145-8G4 and open the fan door.
  3. Tighten the thumbscrew  1 , which is shown in Figure 1, until the cover correctly engages all the inset tabs on the SAN Volume Controller 2145-8G4.
    Figure 1. SAN Volume Controller 2145-8G4 with the fan door openThis figure shows the SAN Volume Controller 2145-8G4 with the fan door open
  4. Close the fan door  2 .
  5. Replace the node in the rack.
Parent topic: Replacing the top cover
Library | Support | Terms of use | Feedback
© Copyright IBM Corporation 2003, 2009. All Rights Reserved.