Replacing the SAN Volume Controller 2145-CF8 in a rack

Follow these instructions when you are prompted to replace the SAN Volume Controller 2145-CF8.

1. Place the SAN Volume Controller 2145-CF8 in the rails on the rack.
   1. Pull the slide rails forward ( 1  in Figure 1) until they click twice into place.
   2. Carefully lift the server and tilt it into position over the slide rails so that the rear nail heads  2  on the server line up with the rear slots  3  on the slide rails.
   3. Slide the server down until the rear nail heads slip into the two rear slots; then slowly lower the front of the server  4  until the other nail heads slip into the other slots on the slide rails.
   4. Verify that the front latch  5  slides over the nail heads.
   Figure 1. Installing the SAN Volume Controller 2145-CF8 node in the slide rails of the rack

   
2. Lift the locking levers ( 1  in Figure 2) on the slide rails and push the server  2  all the way into the rack until it clicks into place.
   Figure 2. Raising the SAN Volume Controller 2145-CF8 locking levers of the slide rails of the rack

   
3. Replace the cable-management arm. See Replacing the cable-management arm.
   
4. Reconnect the fibre-channel and Ethernet cables. Ensure that you replace the fibre-channel and Ethernet cables in the same ports from which they were removed.
   
5. Connect the power cable to the node and replace the cable-retention bracket. See Replacing the cable-retention bracket.
   
6. Replace the cable-management arm, as described in Replacing the cable-management arm.
7. Turn on the node.