Replacing the SAN Volume Controller 2145-8G4 fans

This topic describes how to replace the SAN Volume Controller 2145-8G4 fans.

Take precautions to avoid damage from static electricity. Wear an anti-static wrist strap and use a static-protected mat or surface. For more information, see Handling static-sensitive devices. The replacement procedures in this topic assume that the following are true:

The failed fan is removed
The node power is turned off
The node is removed from the rack

Perform the following steps to replace a failed fan:

Orient the new fan in the same position as the fan that you removed. Make sure that the airflow indicator on the orange tab, ( in Figure 1) is pointing to the rear of the node.
Figure 1. SAN Volume Controller 2145-8G4 fan doors, locations, and connectors
Push the fan assembly down into the server until the blue mounting grommets are correctly seated.
Connect the cable of the replacement fan into the system board connector.
Close the fan door .
Place the node in the rack. See Replacing the SAN Volume Controller in a rack.
Turn on the node.