Replacing the SAN Volume Controller 2145-8G4 fibre-channel adapter assembly

Perform the following steps to replace the SAN Volume Controller 2145-8G4 fibre-channel adapter assembly:

1. As you start inserting the adapter, align the edge connector on the low-profile adapter  with the connector  on the riser-card assembly  Make sure that the adapter snaps into the riser-card securely. Press the riser-card edge connector firmly into the system-board connector. , as shown in Figure 1.
   Figure 1. Replacing the riser-card assembly for the SAN Volume Controller 2145-8G4

   
   • Fibre-channel adapter
   • Adapter support bracket
   • Riser-card-adapter connector
   • Riser-card assembly
   • System-board-riser-card connector
2. Replace the top cover. See Replacing the top cover.
   
3. Place the node in the rack. See Replacing the SAN Volume Controller in a rack.
   
4. Replace the cables that were removed from the node, and make sure that you replace the fibre-channel cables in the same ports from which they were removed.
5. Replace the cable-retention bracket. See Replacing the cable-retention bracket.