This topic describes how to replace the SAN Volume Controller 2145-8G4 power
backplane.
Take
precautions to avoid damage from static electricity. Wear an anti-static
wrist strap and use a static-protected mat or surface. For more information,
see Handling static-sensitive devices.
Perform the following steps to replace the power backplane:
- Align the keyhole slots in the power-supply backplane with
the mounting pins in the node.
- Slide the power-supply backplane toward the right side
of the node until the edge-connectors are fully connected.
- Reconnect the cables to the power-supply backplane.
- Install the power supply into the power-supply bay as shown
in Figure 1.
Figure 1. SAN Volume Controller 2145-8G4 power
backplane
- Replace
the top cover. See Replacing the top cover.
- Place the node in the
rack. See Replacing the SAN Volume Controller in a rack.
- Reconnect the fibre-channel
and Ethernet cables. Ensure that you replace the fibre-channel
and Ethernet cables in the same ports from which they were removed.
- Turn on the node.