The 2145 UPS-1U cable-retention
bracket ensures that the power cable connection between the 2145 UPS-1U and
the SAN Volume Controller node
is stable.
Install the bracket after you
install the power and signal cable assembly that was supplied with
the node to connect the 2145 UPS-1U and
the node.
You can attach the bracket by performing the following steps:
- Install the power cable into the rightmost power outlet
on the rear of the 2145 UPS-1U.
- Remove the bracket and the two screws (shown in Figure 1) from the packaging.
Figure 1. 2145 UPS-1U power
cable-retention bracket hardware
- Place the bracket over the power outlets on the right rear
of the 2145 UPS-1U,
so that the two screw holes line up.
- Position the bracket with the power cable protruding through
the rightmost slot in the bracket.
- Secure the bracket in place with one screw on each side,
as shown in Figure 2.
Figure 2. 2145 UPS-1U power
cable-retention bracket
