Use the Remove Blade screen to select an FC I/O blade that has been permanently removed from the library.
Library firmware monitors all FC I/O blades after they are installed in the library. Once an FC I/O blade is installed, the library expects the blade to be in the same installed location after every power cycle. If an FC I/O blade is permanently removed or relocated to another location in the library, the library firmware must be configured to stop monitoring the blade location. This is done by selecting the removed FC I/O blade from the Remove Blade screen. If this is not done, a Reliability, Availability, and Serviceability (RAS) ticket could be generated.
You do not need to configure the library to stop monitoring an FC I/O blade if the failed blade is replaced with a new FC I/O blade.
Note: For instructions on how to remove and replace an FC I/O blade customer replaceable
unit (CRU), see the
The Remove Blade screen lists the location and state of each FC I/O blade.
Do the following:
Note: At any time, select Back to return to the previous screen. Select Cancel to return to the Setup menu.