Fujitsu PRIMEPOWER host attachment

This section describes how you attach a Fujitsu PRIMEPOWER host to a DS6000™ using a fibre-channel Emulex adapter.

Before you attach a host, review the following information:

The General requirements for attaching a host system
The DS6000 Interoperability Matrix at http://www.ibm.com/servers/storage/disk/ds6000/ for the most current information and details for hosts, operating systems, adapters, switches and microcode
A list of supported host bus adapters (HBAs), firmware, and device driver information for your host system and host adapter at http://www-03.ibm.com/servers/storage/support/config/hba/index.wss

Note: If you are installing the fibre-channel adapter for the first time, you must specify the correct topology. You must also select the appropriate device mapping driver.

Installing the Emulex adapter for a PRIMEPOWER host
This section tells you how to configure an Emulex adapter card and driver for a PRIMEPOWER host.
Locating the WWPN for a Fujitsu PRIMEPOWER host
Complete this task to locate the WWPN for a PRIMEPOWER host system adapter.

Parent topic: DS6000 host attachment

Related information

General requirements for attaching a host system