Parameter settings for the QLogic QLA23xxF adapters for a Sun host

You can use these recommended configuration settings for your QLogic adapters on a Sun host system.

Table 1 provides configuration settings that are recommended for the QLogic QLA2310F, QLA2340, and QLA2342 adapters. These settings are for a host that is attached directly to DS6000™ or through a fabric switch.

Table 1. Recommended configuration file parameters for the QLogic QLA2310F, QLA2340, and QLA2342 adapters with driver level 4.03
Parameters	Recommended settings
hba0-max-frame-length	=2048;
hba0-max-iocb-allocation	=256;
hba0-execution-throttle	=31;
hba0-login-timeout	=4;
hba0-login-retry-count	=1;
hba0-fabric-retry-count	=10;
hba0-adapter-hard-loop-ID	=0;
hba0-enable or disable-64bit PCI DMA addressing	=0: disabled =1: enabled
hba0-enable or /disable-LIP-reset	=0: disabled
hba0-enable or disable-LIP-full-login	=1: enabled
hba0-enable or disable-target-reset	=0: disabled
hba0-reset-delay	=5;
hba0-port-down-retry-count	=30;
hba0-link-down-error	=1: enabled
hba0-link-down-timeout	=60;
hba0-connection-options	=0: loop only (for direct attachment) =1: point-to-point only (for fabric attachment)
hba0-device-configuration-mode	=1: use port name
hba0-fc-tape	=0: disabled =1: enabled
hba0-fc-data-rate	=2: Auto-negotiate
hba0-command-completion-option	=0: response queue
persistent binding only option	=0: reports the discovery of persistent binded and non-binded devices to the operating system