Complete this task to upgrade the IBM® System
Storage™ DS Storage Manager in
your Windows environment using the unattended (silent) mode.
It is recommended that you upgrade the level of code before upgrading
the DS Storage Manager.
Notes: - The name of the user who logs on and performs the installation
must not contain any non-ASCII or special characters. It could cause the installation
to fail.
- The DS Storage Manager is
not supported on any Windows 64-bit operating system.
The unattended (silent) mode upgrade option allows you to run
the upgrade program unattended. Use this method of upgrade to issue a command
from a command prompt window, in the root directory of the IBM System
Storage DS Storage Manager CD.
Perform the following steps to upgrade the IBM System
Storage DS Storage Manager in your Windows environment using the unattended (silent) mode:
- Log on to your Windows system as an administrator.
- Insert the IBM System
Storage DS Storage Manager upgrade
CD into the CD-ROM drive. If the interactive mode starts, click the Exit selection
on the LaunchPad window to end the program.
- Type the following command at the command prompt: setup.exe
-silent. Press the Enter key to start the upgrade
process in unattended (silent) mode.
- Check the install log file for any possible error messages. This
file is located in the xxx\logs\install.log directory, where xxx is
the destination directory where the DS Storage Manager is
installed.
- Start the IBM System
Storage DS Storage Manager if
no errors are evident.
- Perform the postinstallation tasks when the DS Storage Manager has
been installed successfully.