Complete this task to install or replace fiber optic cables and small form factor pluggables (SFPs).
CAUTION:
This product may contain one or more of the following: CD-ROM,
DVD-ROM, DVD-RAM, or laser module, which are Class 1 laser products. Please
note the following:
- Do not remove the covers. Removing the covers of the laser product could result in exposure to hazardous laser radiation. There are no serviceable parts inside the device.
- Use of the controls or adjustments or performance of procedures other than those specified herein might result in hazardous radiation exposure.
CAUTION:
Data processing environments can contain
equipment transmitting on system links with laser modules that operate at
greater than Class 1 power levels. For this reason, never look into the end
of an optical fiber cable or open receptacle.
Use approved ESD procedures to prevent damage.
Important: If you removed the fiber optic cables
during a replacement procedure, you must replace the fiber optic cables in
the same ports that you removed them from.
The fiber optic ports are located on the processor card in the enclosure.
- Lift the wire or plastic tab and remove the protective cap from the SFP module.
- Remove the protective cap from the SFP module port on the server enclosure.
- Insert the SFP module into the SFP module port on the server enclosure.
- Remove the protective caps from the fiber optic cable.
- Insert the fiber optic cable into the SFP module.
- Check to ensure that both the SFP module and fiber optic cable are properly seated in the port.