Installing a resource

This section contains the steps that you must follow to replace or install a resource in your server or expansion enclosure. You can also follow the steps in this section if you are performing field upgrades.

You can replace or install the following resources in your server or expansion enclosure to repair a fault or other resource event:

• Disk drive module
• Front display panel
• Rear operator panel
• Power supply
• Processor card
• Battery backup unit
• System service card
• Fiber optic cables and SFPs
• Power cable

• Installing the disk drive module
  Complete this task to install or replace a disk drive module.
• Installing the front display panel
  Complete this task to install or replace the front display panel or the right front bezel. If you are installing the front panel display after removing it for a servicing procedure, you can install it whether the system is powered off or powered on.
• Installing the power supply
  Complete this task to install or replace the power supply, either when the system is powered off or powered on.
• Installing the rear operator panel
  Complete this task to install or replace the rear operator panel, either when the system is powered off or powered on.
• Installing the battery backup unit
  Complete this task to install or replace the battery backup unit, either when the system is powered off or powered on.
• Installing the processor card
  Complete this task to install or replace the processor cards in a server or expansion enclosure, either when the system is powered off or powered on.
• Installing the system service card
  Complete this task to install or replace the system service card.
• Installing the fiber optic cables and SFPs
  Complete this task to install or replace fiber optic cables and small form factor pluggables (SFPs).
• Installing the power cord
  Complete this task to install or replace the power cord for your storage unit.