Replacing the disk drive module

If you removed the disk drive modules from the enclosure to reduce the weight of the enclosure before installation, complete this task to replace the disk drive modules in the enclosure.

The disk drive modules are located in rows and columns on the front of the storage unit.

To replace the disk drive modules, perform the following steps:

1. Before installing the disk drive module, open the disk drive module handle by pressing the blue latch and pulling the handle open.
2. Align the disk drive module with the groove on the disk drive module bay and push it into its slot. The drive stops before it is fully seated. Ensure that the disk drive is properly aligned in a horizontal position. Failure to do so could result in physical damage to the drive or the drive component.
3. Push the disk drive module handle to the right until it is latched closed.
4. Verify that the front of the disk drive module is aligned with the other disk drive modules.

These images show a disk drive module replacement procedure.

Important: All disk drive module slots must be filled to prevent overheating the storage unit. If necessary, insert a disk drive module blank in an empty slot.