Replacing the hardware resources

This section contains information that helps you replace the hardware resources in the enclosure after installing the enclosure in the rack. If you did not remove the hardware resources before installation, you can skip this section.

1. Make sure to follow ESD procedures by using an anti-static wrist strap.
2. Replace all the hardware resources in the DS6000™ expansion and server enclosures that were previously removed.

• Replacing the disk drive module
  If you removed the disk drive modules from the enclosure to reduce the weight of the enclosure before installation, complete this task to replace the disk drive modules in the enclosure.
• Replacing the power supply
  If you removed the power supplies to reduce the weight of the enclosure before installation, complete this task to replace the power supplies.
• Replacing the rear display panel
  If you removed the rear display panel to reduce the weight of the enclosure before installation, complete this task to replace the rear display panel.
• Replacing the battery backup unit
  If you removed the battery backup units to reduce the weight of the enclosure before installation, complete this task to replace the battery backup units.
• Replacing the processor cards
  If you removed the processor cards to reduce the weight of the enclosure before installation, complete this task to replace the processor cards.
• Installing the front display panel
  Complete this task to install or replace the front display panel or the right front bezel. If you are installing the front panel display after removing it for a servicing procedure, you can install it whether the system is powered off or powered on.