Specifying storage unit day and time (real-time only)

Complete this task to specify date, time, time zone, and Daylight Saving time observation setting for the selected storage unit.

Important: The date and time on the storage unit must be set correctly and must match the date and time settings on the management console. If this information is not set correctly, the error logs for the storage unit will not be correct.

You must make a selection in the table to enable this option.

To specify storage unit day and time, perform the following steps:
  1. In the navigation, select Real-time manager > Manage hardware > Storage units. Select the appropriate storage unit.
  2. In the Select Action list, select Configure, and then click Go. The Storage unit properties page is displayed.
  3. In the navigation on the left, click the Date and time tab. The Date and time zone page is displayed.
  4. Specify the date, time, and time zone for the selected storage unit.
  5. Click OK to save and close.

If you are setting up the DS Storage Manager, return to Setting up the DS Storage Manager and complete the rest of the steps.

Parent topic: Setting up the DS Storage Manager
Parent topic: Storage units
Library | Support | Terms of use | Feedback
© Copyright IBM Corporation 2004, 2007. All Rights Reserved.