cc#-01-i.01
-
This illustration shows the geometry that you create in 
this section. 
Choose option
-
cc#-01-i.02
- 
The arc you will create is shown as a dashed yellow  
entity.                                            
Choose option
- 
Choose the CREATE option. 
  
Choose option 
- 
Choose the ARC option. 
  
Choose option 
- 
Choose the CTR+RAD option. 
  
Choose option 
- 
Enter a radius of 0.375 for the arc. 
  
Enter radius (0.25) => 
radius 
- 
Enter an angle of 90 degrees for the starting point. 
  
Enter start angle (0) => 
start angle 
- 
Enter an angle of 270 degrees for the ending point. 
  
Enter end angle (360) => 
end angle 
- 
cc#-01-i.03
- 
Choose the DELTA option to indicate the center. 
  
Indicate center / Cursor-indicate position 
- 
cc#-01-i.04
- 
Use the INTRSCT option to indicate the delta reference 
position. 
Indicate delta reference position / Cursor-indicate position 
- 
Select the highlighted line. 
  
Indicate delta reference position / Select 1st entity 
line
- 
Select the highlighted line. 
  
Indicate delta reference position / Select 2nd entity 
line
- 
Enter -1.25 as the x delta value. 
  
dXV = 
dXV 
- 
Enter 1.25 as the y delta value. 
  
dXV = -1.25             dYV = 
dYV 
- 
Enter 0.0 as the z delta value. 
  
dXV = -1.25             dYV = 1.25              dZV = 
dZV 
- 
Press ESCAPE to exit from this function. 
  
Indicate delta reference position / Cursor-indicate position 
- 
cc#-01-r.05
-
