.   AlphaServer SRM Console Bootstrap Commands?   The Question is:    L what are the commands to boot into the Factory installed software first time3  log on, it is a DS25 need to load software liences      The Answer is :   E   Please read the provided documentation, as the OpenVMS Wizard would B   expect that the particular console SHOW and BOOT commands neededF   would be documented.  Failing that, please see the owner's guide forG   the AlphaServer DS25 and the OpenVMS installation and upgrade manual.    F   Most commonly, the SRM console commands involved are SHOW DEVICE andC   then BOOT ddcu, where ddcu is the name of the target system disk. -   The specific device name can and does vary.       For example:    show device     dkc0.0.0.9.0 DKC0 RZ1DB-BA LYG0 # dkc100.1.0.9.0 DKC100 RZ1CB-CA LYJ0 # dkc200.2.0.9.0 DKC200 RZ1CB-CA LYJ0 # dkc300.3.0.9.0 DKC300 RZ1CB-CA LYJ0   dkc500.5.0.9.0 DKC500 RRD47 1337 dva0.0.0.0.0 DVA0 # ewa0.0.0.8.1 EWA0 00-00-F8-00-0E-3B $ pkc0.7.0.9.0 PKC0 SCSI Bus ID 7 5.54    boot dkc100    E   The above example shows five SCSI (DK) disks, a floppy (DV) disk, a F   network (EW), and a SCSI controller (PK), and shows a bootstrap from,   the second of the five SCSI disks present.   0  Answer written or last revised on  30-APR-2004 