Article ID: 101238
Article Last Modified on 10/13/2003
APPLIES TO
- Microsoft Windows for Workgroups 3.1
- Microsoft Windows for Workgroups 3.11
This article was previously published under Q101238
SYMPTOMS
If you use the NETAPI.DLL file and NetWare with Microsoft Windows for
Workgroups (WFWG) version 3.1, you receive the following error message:
Undefined call to Dynalink
-or-
Call to Undefined Dynalink
CAUSE
The NETAPI.DLL file included with WINUP7.ZIP is designed for use with
Microsoft Windows 3.1.
The NETAPI.DLL file included with WINUP8.ZIP is designed to add support for
Novell named pipes. Windows for Workgroups 3.1 and 3.11 do not support
Novell named pipes.
WORKAROUND
To correct the problem, follow these steps:
- Close the error message. This exits Windows for Workgroups.
- Rename the NETAPI.DLL file in the \WINROOT directory and any others
found in the PATH statement.
- Use the NETAPI.DLL file provided with Windows for Workgroups by
expanding it from your original disks. For example, type the following
at the MS-DOS command prompt, and then press ENTER:
expand a:\netapi.dl_ c:\windows\system\netapi.dll
NOTE: Refer to the following table to determine on which disk the
NETAPI.DL_ file is located:
5.25-inch disks 3.5-inch disks
---------------------------------------------
WFWG 3.1 disk 1 disk 2
WFWG 3.11 disk 8 disk 7
Additional query words: 3.1 3.10 3.11 novell \WINROOT OLDDLLS subdirectory
Keywords: KB101238