Unable to Access Corel LS2000 SCSI After Upgrading

MORE INFORMATION

CUNI_LS2.SYS

If you try to load CUNI_LS2.SYS with MS-DOS 6.0, you may receive the following error message: When the computer has finished booting, the SCSI device is not accessible. To work around this problem, you must specify the address range that the device uses. Using the following syntax, add the /MEM switch to the line in the CONFIG.SYS file that loads CUNI_LS2.SYS

   DEVICE=<drive><path>CUNI_LS2.SYS /MEM:<;xxxx-xxxx>
				

where <xxx-xxxx> represents the entire address range at which the device is located. The default for this range is D800-DBFF, however, it can be changed using hardware switches.

CUNIASP.SYS

If you try to load CUNIASP.SYS, no error message occurs, but the SCSI device is still inaccessible.

To specify the address range while using CUNIASP.SYS, an additional device driver must be loaded. The device driver ASPLS_D.SYS should be loaded immediately before CUNIASP.SYS in the CONFIG.SYS file and should have the following syntax

   DEVICE=<drive><path>ASPLS_D.SYS /LS2000,<xxxx>,3
				

where <xxxx> represents the starting address used by the LS2000. The default starting address is D800.

For more information on the above device drivers and the LS2000 SCSI device, call Corel Technical Support.