Knowledge Base

Adaptec 1540B SCSI Requires Update for 1GB or Larger Hard Disk

Article ID: 105180

Article Last Modified on 3/16/2004

APPLIES TO

This article was previously published under Q105180

SUMMARY

The Adaptec 1540B SCSI host adapter requires firmware revision 3.20 when used with 1GB or larger hard disks.

Symptoms of not having firmware revision 3.20 may include the following:
  • The computer does not recognize the disk.
  • The disk formats to less than 1GB.
  • Windows NT reports "Inaccessible boot device" or hangs during boot.
There are two ways to determine if firmware revision 3.20 is installed:
  • Cold boot the computer and read the version displayed by the Adaptec BIOS. -or-

  • Pull the card out of the computer and inspect the chips.

MORE INFORMATION

To inspect the card for firmware revision 3.20 look on the component side of the card with the ISA connector on the bottom.
  • The chip on the lower-right should be number BD00.
  • The chip in the middle-left should be number 3054.
If either of these numbers is different, the firmware revision 3.20 is not installed.

For further information or to obtain this update, please call Adaptec Technical Support at 1-800-959-7274.

The Adaptec products included here are manufactured by a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding these products' performance or reliability.

Additional query words: prodnt

Keywords: kbhardware KB105180


Send feedback to Microsoft

© Microsoft Corporation. All rights reserved.