DigiBoard 2Port Adapter Setup Fails with U.S. Service Pack 1
Article ID: 108413
Article Last Modified on 11/1/2006
APPLIES TO
- Microsoft Windows NT 3.1 Service Pack 1
- Microsoft Windows NT 3.1 Service Pack 1
This article was previously published under Q108413
SYMPTOMS
If you set up the DigiBoard 2Port Adapter, after installing U.S. Service
Pack 1, the Port Settings dialog box, used to enumerate and install
additional COM ports, is not displayed. Therefore, some of the
configuration parameters are not correctly written to the Registry. If you
restart your computer, you receive an error message. If you use the Network
portion of Control Panel to remove the driver, you still receive an error
message.
WORKAROUND
To work around this problem, remove the adapter (ignoring the error
message) and replace the OEMNADDS.INF file of Service Pack 1 with the
version supplied from your original Windows NT media (build 511) using the
EXPAND command. Reinstall the adapter using the Network portion of Control
Panel. This version is smaller in size (62182), therefore possible
incompatibilities with other DigiBoard drivers could exist.
STATUS
Microsoft has confirmed this to be a problem in Microsoft U.S. Service Pack
1 for Windows NT and Windows NT Advanced Server version 3.1. We are
researching this problem and will post new information here in the
Microsoft Knowledge Base as it becomes available.
Additional query words: prodnt DigiBoard OEMNADDS
Keywords: kbhardware KB108413