Knowledge Base

Fujitsu M2511A Doesn't Recognize Disk Change

Article ID: 111679

Article Last Modified on 4/12/2004

APPLIES TO

This article was previously published under Q111679

SYMPTOMS

Windows NT fails to recognize a disk change in Fujitsu M2511A Magneto Optical disk drive. The directory displayed is the same as the previous disk.

CAUSE

The disk drive is shipped with incorrect settings for proper operation with Windows NT. The default settings do not recognize the Unit Attention signal which is generated when an error or disk change occurs. The system ignores this event and does not recognize disk changes.

RESOLUTION

To allow the drive to operate correctly the drive switches must be configured as follows:

There are two switch blocks, SW1 and SW2. SW1 has four switches and SW2 has eight. SW2-3 and SW2-5 must be on and SW2-7 must be off in order for Windows NT to recognize disk changes. In addition, the disk must be partitioned with Disk Administrator as type FAT.

MORE INFORMATION

Switch SW1

SW1 determines the SCSI ID. It has the following configurations: 
   SCSI ID   SW1-2   SW1-3   SW1-4
   -------------------------------
   0         OFF     OFF     OFF
   1         OFF     OFF     ON
   2         OFF     ON      OFF
   3         OFF     ON      ON
   4         ON      OFF     OFF
   5         ON      OFF     ON
   6         ON      ON      OFF
   7         ON      ON      ON
NOTE: SW1-1 is not used and should remain in the off position.

Switch SW2

SW2 has the following settings: 
   SW2-1: SCSI Parity check (ON - Enabled*, OFF - Disabled)
   SW2-2: Synchronous Data Transfer (ON - Enabled, OFF - Disabled*)
   SW2-3: Device Type Selection (ON - Removable Magneto Optical Disk**,
          OFF - Fixed Disk - Non Removable*)
   SW2-4: Spindle Auto Stop Mode (ON - Spindle stops when idle*,
          OFF - Spindle always stays on)
   SW2-5: Page Code 1 Byte Parameter (ON - 10 byte parameter page length
          and 6 byte page length descriptor**, OFF - 6 byte parameter page
          length and 10 byte page length descriptor*)
   SW2-6: Factory Test Option (ON - Factory Test Mode, OFF - Normal
          Operation*)
   SW2-7: Report Unit Attention (ON - Do not report Unit Attention*,
          OFF - Report Unit Attention per ANSI Spec.**)
   SW2-8: Factory Diagnostic Setting (ON - Enable Sending Diagnostic,
          OFF - Disable Run/Receive Diagnostic*)
*Factory Settings **Modification to factory defaults for proper operation under Windows NT and Windows NT Advanced Server

Additional query words: prodnt

Keywords: kbhardware kbsetup KB111679


Send feedback to Microsoft

© Microsoft Corporation. All rights reserved.