Knowledge Base

PRB: Setup Does Not Detect Existing FoxPro Installation

Article ID: 120840

Article Last Modified on 10/15/2003

APPLIES TO

This article was previously published under Q120840

SYMPTOMS

The Setup program prompts you to install FoxPro, rather than running in maintenance mode to modify an existing FoxPro installation.

CAUSE

FoxPro is installed on a hard disk (volume) other than the boot disk. The setup program only checks the boot disk for an existing FoxPro installation.

STATUS

This behavior is by design.

MORE INFORMATION

When FoxPro is installed on the boot disk, the FoxPro Setup program starts in maintenance mode, prompting you to add or remove components of your current installation, reinstall FoxPro, or remove all FoxPro components of the current FoxPro installation.

Additional query words: VFoxMac FoxMac drive akz

Keywords: kbsetup kbprb KB120840


Send feedback to Microsoft

© Microsoft Corporation. All rights reserved.