Detailed Description of INTERLNK Parallel Cable Pinouts
Article ID: 121246
Article Last Modified on 11/19/1999
APPLIES TO
- Microsoft MS-DOS 6.0 Standard Edition
- Microsoft MS-DOS 6.2 Standard Edition
- Microsoft MS-DOS 6.21 Standard Edition
- Microsoft MS-DOS 6.22 Standard Edition
This article was previously published under Q121246
SUMMARY
The following signal descriptions are for the parallel cable pins required
to use Interlnk.
Pin 2: Data Bit 0 Active when High
Pin 3: Data Bit 1 Active when High
Pin 4: Data Bit 2 Active when High
Pin 5: Data Bit 3 Active when High
Pin 6: Data Bit 4 Active when High
Pin 10: Acknowledge Active when Low
Pin 11: Busy Active when High
Pin 12: Out Of Paper Active when High
Pin 13: Select Active when High
Pin 15: Error Active when Low
Pin 25: Ground
MORE INFORMATION
Descriptions of parallel and serial cables required to run Interlnk can be
found in MS-DOS Help. For more information, type help interlnk-- notes at the MS-DOS command prompt and then press
ENTER.
Additional query words: 6.00 6.20 inter link interlink
Keywords: KB121246