Article ID: 123804
Article Last Modified on 9/25/2003
APPLIES TO
- Microsoft Works 3.0 Standard Edition
- Microsoft Works 3.0a
- Microsoft Works 3.0b
This article was previously published under Q123804
SYMPTOMS
When you try to access Works 3.0 templates through either the Startup
dialog box or the File menu, your system may hang (stop responding) or the
following error message may occur:
Bad Template Entry.
CAUSE
This problem may be caused by invalid entries in the [Template Section] of
the MSWORKS3.INI file or by problems with a math coprocessor--for example,
with the 80387 chip on a 386 system.
RESOLUTION
Invalid MSWORK3.INI [Template Section] Entries
For example, if the TemplateMax= line is set higher than the actual number
of templates, it will cause this error. To correct this problem, change the
TemplateMax= line to match the number of templates, save the MSWORKS3.INI
file in text format, and restart Works.
To correct other problems with the [Template Section] of the MSWORKS3.INI
file, remove the entire section and rebuild it. For more information about
rebuilding this section of the MSWORKS3.INI file, see the following
article:
121622 Re-creating the [Template Section] of the MSWORKS3.INI File
Problems with the Math Coprocessor
It has been reported that this problem may occur on computers with math
coprocessors installed where the coprocessor is incorrectly installed or
configured. For example, the jumper or DIP switches may be set wrong, or
the math coprocessor may not be completely seated in its socket.
Contact the hardware manufacturer to verify the proper installation and
setting for the math coprocessor chip.
This cause of the problem has not been confirmed or tested by Microsoft.
Additional query words: co-processor processor err msg prob fail 80387 387 hang hung hanging locks locked frozen freezes quit quits stop responding stopped crash crashed crashes crashing bomb
Keywords: KB123804