How to Set Up IBM Token Ring PCMCIA for Windows for Workgroups

MORE INFORMATION

1. Determine the interrupt (IRQ), I/O port address, RAM address and ROM address you are going to use for the network adapter. These can be configured through the notebook computer's Setup software. The RAM and ROM locations may be specified as Memory Window 1 and Memory Window 2.
   
   Example

   Memory Window 1: D4h
   Memory Window 2: D8h
   

   In this example, the ROM starting address is D400h. The memory range is from D400 to D7FF. The RAM starting address is D800h. The memory range is from D800 to DFFF.
2. When you configure the network adapter through Adapter Configuration in Network Setup, the following is added to the PROTOCOL.INI file:

         [IBM_TRCC]
         ;IBM Token-Ring 16/4 Credit Card
         DriverName=IBMTOK$
         RINGSPEED=4
         AUTORINGSPEED
         PCMCIA
         MAXTRANSMITS=6
         RECVBUFS=2
         RECVBUFSIZE=256
         XMITBUFS=1
         XMITBUFSIZE=2040
         INTERRUPT=<IRQ>
         RAM=0xD800
         MMIO=0xD400
   						

   NOTE: The Ring Speed can be set in this section to either 4 or 16. The Interrupt setting should be the same as that selected in the notebook computer's Setup utility. The RAM=0xD800 corresponds to the Memory Window 2 setting. The MMIO=0xD400 corresponds to the Memory Window 1 setting and represents the ROM address.
3. Modify the CONFIG.SYS file to exclude the RAM and ROM addresses being used by the adapter, as follows:

         Device=c:\dos\emm386.exe noems x=D400-D7FF x=D800-DFFF
   						

   -or-

         Device=c:\dos\emm386.exe noems x=D400-DFFF
   						

   NOTE: Verify that the notebook Setup utility settings for the adapter, the settings specified in PROTOCOL.INI, and the excluded memory ranges in CONFIG.SYS match.