How to Add an IDE Drive and Controller to SCSI Windows NT System

MORE INFORMATION

Create a New Windows NT Boot Disk

1. Under Windows NT, format a floppy disk.
2. Copy NTLDR, NTDETECT.COM, and BOOT.INI from your normal boot drive to the floppy disk. (These files may have the read-only, system, and hidden attributes).
3. Locate the driver for the SCSI controller that you currently boot from and copy it to the floppy disk as NTBOOTDD.SYS. For example, type the following for an Adaptec 1542 controller:

   copy %systemroot%\system32\drivers\aha154x.sys a:\ntbootdd.sys

4. Edit the BOOT.INI file on the floppy disk. Change each occurrence of multi to scsi.
5. Turn off the computer, install the IDE drive and controller, and restart the computer.
6. Make sure to change the CMOS settings to include the new drive. You should be able to boot from the floppy disk and have it boot the installation of Windows NT that is already on your SCSI drive.

Set Up The New IDE Drive

1. Boot with a MS-DOS system disk.
2. Run FDISK.EXE and examine the partition information for the drive.
3. Create a partition on the IDE drive if necessary. Be careful to only make changes to the partition table on the IDE drive.
4. Quit FDISK and reboot. Format the drive as follows:

   FORMAT C: /S

5. Perform any additional setup of other media devices that may be required for MS-DOS to access your Windows NT installation media.

Install Windows NT Boot File On The New IDE Drive

1. Run Windows NT Setup. If you have the Windows NT CD-ROM and can access it from MS-DOS, run WINNT /B from the MS-DOS command prompt. This performs a floppyless installation.
2. When asked to reboot the computer, do so with an MS-DOS boot disk in Drive A.
3. Copy the BOOT.INI and NTBOOTDD.SYS files from the Windows NT Boot disk to the new IDE drive.
4. Delete the temporary Windows NT installation directory (if any) on the new IDE drive.
5. Remove the disk from the floppy drive and reboot the computer.

Enable IDE Disk Support In Windows NT

1. Copy the ATDISK.SYS file from the Windows NT installation media to the %SYSTEMROOT%\SYSTEM32\DRIVERS directory.
2. In Windows NT, run Control Panel and choose Devices. Set the startup mode for ATDISK to System. If you want the newly added drive to be first in the order as they appear in Disk Administrator, change the startup mode to Boot.
3. Start the ATDISK driver from Control Panel.
4. Start Disk Administrator and make any changes necessary to the drive letter assigned to the new drive. If you do not choose a drive letter for the new drive, Windows NT will select a drive at the next reboot. This may cause existing drive letter assignments to change.
5. Shutdown and restart Windows NT.