CONN: How to Reset the Mail Queue for Mail Connection 1.0b

MORE INFORMATION

Prior to recreating the MBG and KEY files for the queue, the administrator should return mail from the MSMAIL queue.

1. Stop the Connection Gateway.
2. Run the Mail for PC Networks Administrator's program (ADMIN.EXE).
3. Select the Queue option, and select MSMAIL from the list of network names.
   
   This will display messages that are in the queue.
4. Select the Return option, and use the spacebar to mark each message in the queue.
5. When you are finished marking the messages, press the RETURN key, and answer Yes to the Return Selected Times? prompt.
   
   NOTE: If more than fifty items are in the mailbag, repeat the procedure.

To recreate the queue, it is necessary to find the number of the queue for the Connection Gateway. This number is kept in the NETWORK.GLB file on the postoffice.

1. Copy the NETWORK.GLB file to a local drive.
   
   WARNING! Be careful to work with the correct drive as the NETWORK.GLB file from one postoffice will not be the same as another.
2. Type out the NETWORK.GLB file from the MS-DOS prompt (use the MORE pipe if this is a large file and scrolls off the screen).
   
   Notes:
   
   
   • The network names will be followed by a short blank space and an eight digit number.
   • The MSMAIL gateway name will be followed by a long blank (greater than 20 spaces) prior to an eight digit number.
   • The eight digit number following the long space is the queue number for the MSMAIL gateway.
   Write down the MSMAIL gateway number.
   
   (As an added check, look in the XTN directory, and confirm that there is NOT an XTN file with this number.)
   
   The number obtained from the last step is an eight digit hex number <HEXID>. To reset the gateway queue involves resetting two files: the <HEXID>.MBG and the <HEXID>.KEY.

NOTE: To allow for recovery, make a copy of the <HEXID>.MBG and <HEXID>.KEY files prior to resetting them.

To create new .MBG and .KEY files:

1. From the Administrator program (ADMIN.EXE) menu, choose External-Admin, Create.
2. Create a new postoffice on an existing network, and then quit ADMIN.EXE.
3. Change to the MBG directory of the postoffice, and look for a 0-byte .MBG file with the current date and time.
   
   Write down the number of this MBG file that will be used to find the .KEY file.

To copy the new .MBG and .KEY files:

1. Copy the new 0-byte .MBG file over the corrupt .MBG file. You cannot use the MS-DOS COPY command to copy 0-byte files.
   
   On a Novell NetWare network, use NCOPY.
   
   On a LAN Manager-compatible network, use XCOPY.
2. Change to the KEY subdirectory of the postoffice; issue the MS-DOS DIR command to look for the new KEY file noted in step 3 above.
3. Copy the new 560 byte KEY file over the corrupt .KEY file.
4. In ADMIN.EXE, choose External-Admin, Delete; then delete the new postoffice that was created earlier.