Knowledge Base

Improper Form Feed with Diconix 150 Plus Printer

Article ID: 136843

Article Last Modified on 11/1/2006

APPLIES TO

This article was previously published under Q136843

SYMPTOMS

When you define 4 inch high custom form and then print to a Diconix 150 Plus driver from any application using that form, the printer uses a form feed at the end of the document as if you had used an 8.5 x 11 inch form.

STATUS

Microsoft has confirmed this to be a problem in Windows NT version 3.51. A supported fix is now available, but is not fully regression-tested and should be applied only to systems experiencing this specific problem. Unless you are severely impacted by this specific problem, Microsoft recommends that you wait for the service pack release containing this fix. Contact Microsoft Product Support Services for more information.


Additional query words: prodnt kodak inches 8.5" 11" 8.5x11 4" four

Keywords: kbprint KB136843


Send feedback to Microsoft

© Microsoft Corporation. All rights reserved.