Knowledge Base

INFO: Viruses Known to Interfere with Visual FoxPro Installation

PSS ID Number: 137605

Article Last Modified on 12/14/1999

The information in this article applies to:

This article was previously published under Q137605

SUMMARY

This article lists the viruses that have been detected on hardware after unsuccessful attempts to install Visual FoxPro. After these viruses were detected and cleaned from the hard disk, no further problems were encountered during installation.

MORE INFORMATION

It is important that computer hardware be checked frequently by a virus detection and cleaning utility. Because the number and signatures of viruses are always changing, so are the utilities that can successfully detect and clean them. Microsoft recommends that you consult your local software retailer for information on the latest and best anti-virus utilities.

Preliminary Trouble-Shooting Steps

  1. Perform a "clean boot." For information about how to perform a clean boot, please see the following article in the Microsoft Knowledge Base:

    95314 How to Perform a "Clean Boot" for FoxPro

  2. Ensure a Permanent Minimum Swap File Size of 10 meg (Windows 3.x).
  3. Remark out any unnecessary drivers that are loading in Windows.
  4. Use a plain VGA video driver.
  5. Ensure that shell=Progman.EXE.
  6. Ensure that the "load=" and "run=" lines of the Win.ini file are blank, or commented out.
  7. Remove all programs from the Startup Group.
  8. Perform a Scandisk (Chkdsk /f if not using MS-DOS version 6.0 or later).
  9. Perform a Virus Scan with whatever software is available.

List of Viruses

The following list may not include all viruses that can contribute to Visual FoxPro (or any other product) installation problems:
  1. Virus Name: KELLY Type: Boot-Sector Detected by: McAfee Virus Scan Ver. 2.2 Behavior: When you install Visual FoxPro Standard Edition from 3.5 inch floppy disks immediately after Initializing Setup on Disk 1, you receive a "Not Enough Memory" error message followed by a "Cannot Read From Drive A" error message. Other: This was detected in conjunction with LEANDRO.
  2. Virus Name: LEANDRO Type: Boot-Sector Detected by: McAfee Virus Scan Ver. 2.2 Behavior: When you install Visual FoxPro Standard Edition from 3.5 inch floppy disks immediately after Initializing Setup on Disk 1, you receive a "Not Enough Memory" error message followed by a "Cannot Read From Drive A" error message. Other: This was detected in conjunction with KELLY.

REFERENCES

For more information about detecting or confirming viruses, please see the following articles in the Microsoft Knowledge Base:

Keywords: kbinfo kbsetup KB137605
Technology: kbAudDeveloper kbVFP300 kbVFPsearch


Send feedback to Microsoft

© 2004 Microsoft Corporation. All rights reserved.