PRB: Distribution Setup Fails After Visual FoxPro 3.0b Install

MORE INFORMATION

This situation occurs when the following circumstances are met:

• A newer version of Visual FoxPro for Windows is installed over an existing installation of an older version of Visual FoxPro for Windows.
• The Setup Wizard was used to create distribution disks while the older version of Visual FoxPro was installed.
• The older version of Visual FoxPro was not removed or the \Distrib directory under Visual FoxPro was not deleted prior to installing the newer version of Visual FoxPro.

Steps to Reproduce Behavior

1. Build an .exe in Visual FoxPro for Windows, version 3.0.
2. Run the Setup Wizard, and create a set of distribution disks of the .exe file.
3. Install Visual FoxPro version 3.0b over version 3.0 without deleting the Visual FoxPro directory or removing Visual FoxPro through the Setup program.
4. Rebuild your .exe in Visual FoxPro version 3.0b.
5. Run the Setup Wizard again, and build a new set of distribution disks off the .exe file.
6. Using the distribution disks, run Setup.exe. Setup fails, and the error appears.

NOTE: The Wzsetup.ini file is created when the Setup Wizard is run and retains the user's preferences for future uses of the Setup Wizard. Two copies are created while running the Setup Wizard -- one in Visual FoxPro's main directory and another in the intended distributed application directory. If you intend to install a newer version of Visual FoxPro over an older version without first removing the existing installation, consider deleting the two copies of Wzsetup.ini as new ones are created the first time you run the Setup Wizard again. This will ensure that you have a copy of Wzsetup.ini that refers only to the new version of the Setup Wizard.