Knowledge Base

Buslogic BT-930 Flashpoint LT SCSI Controller Needs OEM Driver

Article ID: 146817

Article Last Modified on 11/1/2006

APPLIES TO

This article was previously published under Q146817

SUMMARY

Buslogic Flashpoint LT PCI SCSI controllers require an OEM (Original Equipment Manufacturer) driver to work properly under Windows NT. If you are installing Windows NT on a system that contains the Buslogic Flashpoint LT SCSI controller you must use the OEM driver disk during Windows NT Setup to recognize attached hard disks and CD-ROMs.

NOTE: Only the flashpoint LT controller driver dated 12-07-95 or later works correctly.

If you do not specify the OEM driver you may experience the following STOP message:
STOP 0x0000007B INACCESSIBLE_BOOT_DEVICE

MORE INFORMATION

This driver can be downloaded by contacting Buslogic.

- Buslogic technical support: (408) 970-1414

- Buslogic BBS: (408)492-1984

- Buslogic World Wide Web: http://www.buslogic.com

The Flashpoint LT PCI SCSI controller discussed here is manufactured by and Buslogic, a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding the products' performance or reliability.

The third-party contact information included in this article is provided to help you find the technical support you need. This contact information is subject to change without notice. Microsoft in no way guarantees the accuracy of this third-party contact information.

Additional query words: prodnt 3.50 3.51

Keywords: KB146817


Send feedback to Microsoft

© Microsoft Corporation. All rights reserved.